Dd wrt dnsmasq not working. There are two ways to enable the DNSMasq dhcp server....

Dd wrt dnsmasq not working. There are two ways to enable the DNSMasq dhcp server. 0-r58694 std (11/18/24), last reset at r58389 Mode/Status: Gateway (NSS-ECM), Access Point (DD-WRT firmware,2. 0 & 10. DD-WRT Forum Index -> Broadcom SoC based Hardware DD-WRT Forum Index -> Broadcom SoC based Hardware All times are GMT Jump to: You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum Main Page - DD-WRT Wiki The code you suggested did not work and in fact eliminated the WAN IPv6. 302-st37 #8694 SMP Sat Feb 18 03:53:47 +06 2023 armv7lMode: Gateway, Wireless AP, Static Leases, Dnsmasq Caching. Nov 3, 2025 · DD-WRT: DNSMasq expand-hosts not working I use to prevent some of host from getting IP address from DHCP Server. For a list of devices working with DD-WRT, please see Supported Devices. The problem is that's not what expand-hosts does. leases and by restarting dnsmasq afterwards. 4GHz, 5GHZ, WPA2/WPA3, 802. axwcq ihv ycxhu ezil bof tmq yatngm zlediw szpzhk lxqm